In this paper, a method of direct spinning is proposed for direct spinning of heterogeneous spun wire-blown holes standard parts and the motherboard mounted on the spin board assemblies. The standardization of the spinneret hole was conducive to improving the machining accuracy and efficiency of the pores, and the spinneret holes could be replaced in time when a hole in the spinneret fails. Moreover; on the other hand, according to the needs of the process of spinning, the spinnerets with various cross-sections were combined and installed on the same motherboard for spinning, and the spinning obtained different bionic new functional products. Based on the results, a finite element model of the standard part of the spinneret hole was developed, and the spinnability of the combinable spinnable spinneret board was verified by simulating the melt flow in the spinneret channel through POLYFLOW software. Further, by the processing of the spinneret, the motherboard was installed into a combined spinneret, and the spinneret assembly was installed on the spinning machine for the experiments. Furthermore, the tow section was observed using a microscope, and the results showed the feasibility of the proposed method.