PreprintArticleVersion 1Preserved in Portico This version is not peer-reviewed
Light Absorption Enhancement and Laser-Induced Damage Ability Improvement of AA 6061 with Non-porous Alumina /CdSe@Al2O3/SiO2 Functional Gradient Films
Yin, J.; Lu, L.; Cui, Y.; Cao, Y.; Du, Y. Light Absorption Enhancement and Laser-Induced Damage Ability Improvement of Aluminum Alloy 6061 with Non-Porous Alumina/CdSe@Al2O3/SiO2 Functional Gradient Films. Nanomaterials2022, 12, 559.
Yin, J.; Lu, L.; Cui, Y.; Cao, Y.; Du, Y. Light Absorption Enhancement and Laser-Induced Damage Ability Improvement of Aluminum Alloy 6061 with Non-Porous Alumina/CdSe@Al2O3/SiO2 Functional Gradient Films. Nanomaterials 2022, 12, 559.
Yin, J.; Lu, L.; Cui, Y.; Cao, Y.; Du, Y. Light Absorption Enhancement and Laser-Induced Damage Ability Improvement of Aluminum Alloy 6061 with Non-Porous Alumina/CdSe@Al2O3/SiO2 Functional Gradient Films. Nanomaterials2022, 12, 559.
Yin, J.; Lu, L.; Cui, Y.; Cao, Y.; Du, Y. Light Absorption Enhancement and Laser-Induced Damage Ability Improvement of Aluminum Alloy 6061 with Non-Porous Alumina/CdSe@Al2O3/SiO2 Functional Gradient Films. Nanomaterials 2022, 12, 559.
Abstract
Numerical calculations of ultraviolet to near-infrared absorption spectra by cadmium selenide quantum dots (CdSe QDs) doped in anodic aluminum oxide pores were performed using a finite-difference time-domain model. The height, diameter, and periodic spacing of the pores were optimized. Light absorption by the dots was enhanced by increasing the height and decreasing the diameter of the pores. When the height was less than 1 μm, visible light absorption was enhanced as the spacing was reduced from 400 nm to 100 nm. No enhancement was observed for heights greater than 6 μm. Finally, the optical mode coupling of the aluminum oxide and the quantum dots was enhanced by decreasing the pore diameter and periodic spacing, and increasing the height. Laser ablation verified light absorption enhancement by the CdSe QDs. The experiment verified the improvement of the laser-induced damage ability with wavelength of 355-nm after aluminum alloy 6061 coated with functional films, which was fabricated based on numerical calculations.
Keywords
CdSe QDs; AA 6061; light absorption; laser ablation
Subject
Chemistry and Materials Science, Metals, Alloys and Metallurgy
Copyright:
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.