PreprintArticleVersion 1Preserved in Portico This version is not peer-reviewed
Optimization of Electron and Hole Transport Layer to Model A Lead-Free Inorganic Cs3Bi2I9 Based Perovskite Solar Cell and Investigating the Effects of Different Attributes on Device Performance
Banik, S., Das, A., Das, B. K., & Islam, N. (2024). Numerical simulation and performance optimization of a lead-free inorganic perovskite solar cell using SCAPS-1D. Heliyon.
Banik, S., Das, A., Das, B. K., & Islam, N. (2024). Numerical simulation and performance optimization of a lead-free inorganic perovskite solar cell using SCAPS-1D. Heliyon.
Banik, S., Das, A., Das, B. K., & Islam, N. (2024). Numerical simulation and performance optimization of a lead-free inorganic perovskite solar cell using SCAPS-1D. Heliyon.
Banik, S., Das, A., Das, B. K., & Islam, N. (2024). Numerical simulation and performance optimization of a lead-free inorganic perovskite solar cell using SCAPS-1D. Heliyon.
Abstract
Research on the lead halide-based perovskite solar cells have obtained considerable interest in photovoltaic industry owing to their higher efficiency, easy manufacturing, light-weight and low cost. However, these lead halide-based solar cells are not suitable to manufacture commercially because of the toxicity of lead-based materials. In this context, a lead-free perovskite, cesium-bismuth iodide (Cs3Bi2I9) is considered as a potential alternative to the lead halide-based cell due to their non-toxicity and stability, but this perovskite cannot be matched with random hole transport layer (HTL) and electron transport layer (ETL) materials compared to lead halide-based perovskite because of their crystal structure and band gap. Therefore, in this study, performance comparison of different ideal HTL and ETL materials for Cs3Bi2I9 perovskite layerwere studied using SCAPS-1D device simulation on the basis of open circuit voltage, short circuit current, power conversion efficiency (PCE) and fill factor (FF) as well as several novel PSC configuration model were designed that can direct for further experimental research for PSC device commercialization. Results from this investigation reveals that the maximum efficiency of 20.96% is obtained for the configuration ITO/WS2/Cs3Bi2I9/NiO/Au with optimized parameters such as thickness 400 nm, band gap 2.1eV, absorber layer defect density 1012 cm-3, donor density of ETL 1018 cm-3 and the acceptor density of HTL 1020 cm-3.
Keywords
Perovskite solar cell; Lead-free Cs3Bi2I9; HTL; ETL; Fill factor; PCE
Subject
Engineering, Mechanical Engineering
Copyright:
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.